This option will bring up the selected programmer window, or will program the chip directly if the 'Auto Flash' option is selected in the Programmer options section. You can use this to determine how much time a program statement takes.ĭo not jump to a conclusion too quick, the time shown might also depend on the value of a variable.įor example, with WAITMS var this might be obvious, but with the division of a value the time might vary too. You will then get a pop up menu with the option to reset the cycles. You can reset the cycles by positioning the mouse cursor on the status bar and then right click.
#Binary editor program j3 chip Pc#
The status bar shows the PC (program counter) and the number of cycles. But only when you have enabled the WD timer. The Simulator will warn you when a WD overflow will occur. So some tolerance is needed when you refresh/reset the WD-timer. Voltage and temperature variations can have an impact on the WD timer. This Watchdog timer is clocked from an internal oscillator. Most AVR chips have an internal Watchdog. Note that using this option will slow down the simulation.
#Binary editor program j3 chip update#
When you use the hardware simulator, the LEDS will only update their state when you have enabled this option. The refresh variables button will refresh all variables during a run(F5). The Real Hardware Simulation is a cost effective way to test attached hardware. The only way to escape is to press the Real hardware Simulation button again. When the program hangs it probably means that something went wrong with the serialĬommunication. Button again to disable the Real hardware simulation.
0 kommentar(er)
